How to draw shear and bending moment diagram (SFD & BMD) of a beam


Comments

Post a Comment

Popular posts from this blog

Types of foundation

Shallow foundation is commonly accepted as foundation with founding level less than 3m from ground surface. In case surface loads or surface conditions could still affect the bearing capacity, the foundation which sits on it is called shallow foundation. Pad foundation refers to the foundation which is intended for sustaining concentrated loads from a single point load such as structural columns. Strip foundation is used to support a line of loads such as load-bearing walls. For instance, closely-spaced columns render the use of pad foundation inappropriate and strip foundation may be a better alternative. Raft foundation consists of a concrete slab which extends over the entire loaded area so that loads from entire structure are spread over a large area leading to a reduction of the stress of foundation soils is reduced. Moreover, raft foundation serves to avoid differential settlement which otherwise would occur if pad or strip foundation is adopted. This question is taken fr...
Read more

Geometrical standards for Runways (Transportation Engineering)

Geometric standards for runways Geometric standards for various runways elements are as follow; 1.   length 2.   width 3.   longitudinal gradient & profile 4.   transverse gradient 5.   runway intersections 1) length Selection of length of a runway is the most important decision in the planning of landing area. Runway lengths for various types of airports recommended by ICAO are for sea level elevation, standard atmospheric conditions; ·         59 0 F or 15 0 C ·         29.92”barometer pressure ·         zero effective gradient ·         No wind The basic lengths recommended by FAA are based on the same conditions except that temperature of 100 0 F (41 0 C above standard) has been included in the length. Necessary corrections have to be applied for changes in elevation, temperature a...
Read more